These are the parts that need to be soldered on top of a BioHack Board V2.0
| No | Amount | Description | Supplier NL | Cost |
|---|---|---|---|---|
| 1 | 2 | Screw Terminal | iPrototype, Farnell | 0.25 |
| 2 | 2 | Female header 8 pin | iPrototype | 1.50 |
| 3 | 1 | Arduino stackable female header set (*1) | iPrototype | 1.75 |
| 4 | 2 | N Channel Power MOSFET | iPrototype, Farnell | 0.91 |
| 5 | 2 | 10 nF capacitor | iPrototype, Farnell | 0.17 |
| 6 | 1 | 100 nF capacitor | iPrototype, Farnell | 0.14 |
| 7 | 7 | 10KOhm resistor | iPrototype, Farnell | 0.03 |
| 8 | 2 | 220 Ohm resistor | iPrototype, Farnell | 0.03 |
| 9 | 1 | 40 Male pin headers | iPrototype, Farnell | 0.75 |
| 10 | 5 | Jumpers | iPrototype, Farnell | 0.10 |
| 11 | 1 | DRV8825 stepper driver | iPrototype | 13.95 |
(*1) You can also find these on Farnell, but at a much higher price by combining two 6 pin headers with two 8 pin headers
Alternatives
Look on eBay for much lower prices