Loving the system so far; I'm about halfway done with my hardware stash. I saw on the Makerworld site that you had some additional icons in the works. If you are still amenable, here are the ones I could use.
Already on your MW list:
- wing nuts
- carriage bolts
- dowel pins
- bearings
And some new ones:
- hex bolts / cap screws / lag bolts
- Wago-style lever nuts (for electrical)
- set screws
- head for T-bolt (like these)
- Euro-screws (like these)
- Pozi-drive drive type
- drywall anchors / toggle bolts / etc.
- pins / brads / crown staples / etc
- springs (compression and extension)
- metal rods (threaded and not)
I tried creating some of these myself in Fusion. They were not good. Graphic design is not my strength.
Anyway, thanks for all you've done on this project so far. It's a winner.
Loving the system so far; I'm about halfway done with my hardware stash. I saw on the Makerworld site that you had some additional icons in the works. If you are still amenable, here are the ones I could use.
Already on your MW list:
And some new ones:
I tried creating some of these myself in Fusion. They were not good. Graphic design is not my strength.
Anyway, thanks for all you've done on this project so far. It's a winner.