I have conducted a simple test calculation to examine the presence of wall lubrication. The approach involved dropping a single particle and allowing it to collide with the wall, followed by observing the distance it rebounded. I performed this validation by comparing the results at a viscosity of 1 Pa·s and 0 Pa·s. Surprisingly, both scenarios yielded identical outcomes.
I am uncertain whether there is an issue with my program or if the source code might be at fault.
Below, I have attached the relevant segment of my code for reference.
Any insights or guidance on this matter would be greatly appreciated.
Thank you
I have conducted a simple test calculation to examine the presence of wall lubrication. The approach involved dropping a single particle and allowing it to collide with the wall, followed by observing the distance it rebounded. I performed this validation by comparing the results at a viscosity of 1 Pa·s and 0 Pa·s. Surprisingly, both scenarios yielded identical outcomes.
I am uncertain whether there is an issue with my program or if the source code might be at fault.
Below, I have attached the relevant segment of my code for reference.
Any insights or guidance on this matter would be greatly appreciated.
Thank you