Humidity measurement off by 10%

[tavdog]

Is there a way to calibrate the humidity sensor ? I have two other sensors agreeing at 46%, meanwhile Aircube is reporting 36%

[StuckAtPrototype]

Hi! Interesting. Sorry, no way to calibrate at the moment other than compiling firmware from scratch. Could you share a bit more detail about the setup you are using to compare it? Also, If you have any data that you can share that would be awesome. Thanks!

[tavdog]

{"etvoc": 800, "temperature_c": 23.41, "eco2": 1044, "aqi": 109, "humidity": 41.57}
I have an Airgradient One device next to the aircube. I also powered up an adafruit magtag with a humidity sensor connected which agreed with the Airgradient. As you can see in the graph, it tracks the Airgradient device but just always 10% low.