When I run vPiP (python test1.py) on a vPiP board v1.0b, the program sits at Polargraph exit until I reset the Arduino Pro Mini at which point the servo does its down-up-down move and then the steppers work...
I opened this against the vPiP board, but have done some debugging on the Arduino firmware and I think the issue is on the vPiP software side, so creating new issue here.
MarkJB/pi-2-stepper-board#6
When I run vPiP (python test1.py) on a vPiP board v1.0b, the program sits at Polargraph exit until I reset the Arduino Pro Mini at which point the servo does its down-up-down move and then the steppers work...
I opened this against the vPiP board, but have done some debugging on the Arduino firmware and I think the issue is on the vPiP software side, so creating new issue here.
MarkJB/pi-2-stepper-board#6