Hi,
Trying to run the arm_test.py file on a Raspberry Pi 3B+ connected to a Pixhawk 4 from USB to TELEM2 port. I configured the TELEM2 port for serial as described at the end of this page
I’m using a USB to TELEM 2 compatible FTDI cable linked here
I’m using the connection string = “/dev/ttyUSB0” with a baud rate of
57600 and I get the following output on terminal: WARNING: dronekit: Link timeout, no heartbeat for last 5 seconds. The connection string with ACM0 or AMA0 doesn’t work either.
Tried a separate serial check code here but gives gibberish with each baud rate.
Not sure where I’m going wrong. Whether it’s the connection string, baud rate or the hardware connection?
Hi,
Trying to run the arm_test.py file on a Raspberry Pi 3B+ connected to a Pixhawk 4 from USB to TELEM2 port. I configured the TELEM2 port for serial as described at the end of this page
I’m using a USB to TELEM 2 compatible FTDI cable linked here
I’m using the connection string = “/dev/ttyUSB0” with a baud rate of
57600 and I get the following output on terminal: WARNING: dronekit: Link timeout, no heartbeat for last 5 seconds. The connection string with ACM0 or AMA0 doesn’t work either.
Tried a separate serial check code here but gives gibberish with each baud rate.
Not sure where I’m going wrong. Whether it’s the connection string, baud rate or the hardware connection?