docs/configuration/

[giscus[bot]]

docs/configuration/

Recommendations for configuring your node and contributing to the mesh.

https://areyoumeshingwith.us/docs/configuration/

[N0YHR]

Question on MQTT configuration. I use the nRF52840 chips, RAK4631, and it does not have Wi-Fi capabilities. I use it for long battery life, but my question is this. If I configure MQTT as instructed, and connect to a node that does have Wi-Fi, will my MQTT packets still make it to the Florida Mesh Map?

I can't test yet as I am in a remote location not reaching any other nodes.

[jbouse]

If a node does not have Wi-Fi or Ethernet, it requires being connected to a device and having the proxy client enabled, or it is pointless to configure MQTT on the node.

[Json-181]

@N0YHR

As @jbouse said, but also you can have these node types report to the map through a networked node (portduino or esp32) by having it in range of a node uplinking to the mqtt and having 'Ok Mqtt' Enabled.

[N0YHR]

Thank you. That makes sense, and I will reenable it. @N0YHR <https://github.com/N0YHR> As @jbouse <https://github.com/jbouse> said, but also you can have these node types report to the map through a networked node (portduino or esp32) by having it in range of a node uplinking to the mqtt and having 'Ok Mqtt' Enabled. — Reply to this email directly, view it on GitHub <#37 (reply in thread)> , or unsubscribe <https://github.com/notifications/unsubscribe-auth/AAC4U3TCCDY3QMZS2LT2WCL3DBY65AVCNFSM6AAAAAB5EXT63WVHI2DSMVQWIX3LMV43URDJONRXK43TNFXW4Q3PNVWWK3TUHMYTGNBTG4YDKNI> . You are receiving this because you were mentioned. <https://github.com/notifications/beacon/AAC4U3VXEAKWY6JAS4UK6M33DBY65A5CNFSM6AAAAAB5EXT63WWGG33NNVSW45C7OR4XAZNRIRUXGY3VONZWS33OINXW23LFNZ2KUY3PNVWWK3TUL5UWJTQAZUEH6.gif> Message ID: ***@***.*** ***@***.***> >