Issue configuring on Void Linux

[longboarder241]

So I attempted to run this build script you set up on my own machine (void i686) and I changed around some of the commands to match my architecture however it seems to constantly get held up on being able to change to the libs folder. I checked the commands including pushd and it seems my system has the proper binaries in place to run this command which leaves me at where I am now where I can't exactly figure out why it won't go past being able to change the libs folder.

[teast]

Hi,

I spent some time looking through this old code.

I have done a new commit where I have updated the script (and some other files) that should work on void linux.

I tested it in qemu and it seems to work.

I no longer have this printer so I cannot verify that the drivers actual work, instead what I did was verify that printuimp495 could be started.

I had to install following packages in void linux for it to compile:

gtk+-devel
cups-devel
popt-devel
tiff-devel
libxml2-devel
glib-devel

And then I updated mp495_build.sh and changed the ARCH variable so it said 32 instead of 64.

after that I did:

./mp495_build.sh configure
./mp495_build.sh build
./mp495_build.sh install

and finally after that I manually created symlinks for all files before I could run printuimp495

[longboarder241]

Dang thats sum dedication. I rlly appreciate it :)