[MSFS] FCU Cube VS Knob Pull Does Not Work with iniBuilds A350

[skylarkning]

Status

Reproduced by @skylarkning

Product

FCU Cube

Bridge Version

V3.0.0.1

Firmware Version

N/A

Simulator

MSFS 2020 / MSFS 2024

Aircraft/Add-on

iniBuilds A350

Issue

When using the Wingflex FCU Cube with the iniBuilds A350 on Bridge V3.0.0.1, pulling the VS knob does not work correctly.

The user reports that the VS knob pull action is not recognized or does not trigger the expected aircraft behavior.

Steps to Reproduce

1. Launch MSFS 2020 or MSFS 2024.
2. Load the iniBuilds A350.
3. Open Wingflex Bridge V3.0.0.1.
4. Connect the Wingflex FCU Cube.
5. Attempt to pull the VS knob on the FCU Cube.
6. Observe whether the aircraft responds to the VS knob pull action.

Expected Result

Pulling the VS knob on the FCU Cube should trigger the correct VS pull behavior (activate VS select mode in the current Vertical Speed) in the iniBuilds A350.

Actual Result

The VS knob pull action is not registered with the iniBuilds A350.

Workaround

No confirmed workaround at this time.

Notes

Reported on the iniBuilds A350 with Bridge V3.0.0.1.