Hi!
First of all, thank you for creating and maintaining HSEM, it's a really cool integration and has already been very useful!
I recently noticed an issue after running HSEM in read-only mode for a couple of months:
- I had mistakenly set my house consumption sensor to the "active power" sensor from my Emma, which reports consumption - solar production (so it frequently goes negative when solar production is high).
- This confused HSEM quite a bit, the estimated battery capacity / time-to-full on the dashboard was constantly showing that the battery would be fully charged in the next ~2 hours… even in the middle of the night with no solar and no grid charging allowed.
I have since corrected it by switching to the proper sensor (emma load power, which only shows house load / consumption).
However, the estimates are still wrong because of all the past negative values that were recorded.
Question:
Is there an easy way to reset / clear the past statistics used by HSEM (e.g. some service call, config option, or command)?
Or do I just need to wait ~14 days (or whatever the statistics window is) for the bad historical data to age out and get overwritten?
Thanks a lot for your help, really appreciate your work on this!
Hi!
First of all, thank you for creating and maintaining HSEM, it's a really cool integration and has already been very useful!
I recently noticed an issue after running HSEM in read-only mode for a couple of months:
I have since corrected it by switching to the proper sensor (emma load power, which only shows house load / consumption).
However, the estimates are still wrong because of all the past negative values that were recorded.
Question:
Is there an easy way to reset / clear the past statistics used by HSEM (e.g. some service call, config option, or command)?
Or do I just need to wait ~14 days (or whatever the statistics window is) for the bad historical data to age out and get overwritten?
Thanks a lot for your help, really appreciate your work on this!