Search results

BOM, build guide, and PCB Gerber export

Status: Open.

#9 In DIYSynthMNL/Pi-Pico-Random-Looping-Sequencer;

· NeoRecasata opened on May 14, 2026

Finalize "Rev 0.2.0" — define bench-test checklist for non-prototype

Status: Open.

#8 In DIYSynthMNL/Pi-Pico-Random-Looping-Sequencer;

· NeoRecasata opened on May 14, 2026

Add test points for power rails, ADC inputs, DAC output, and I²C bus

Status: Open.

#7 In DIYSynthMNL/Pi-Pico-Random-Looping-Sequencer;

· NeoRecasata opened on May 14, 2026

Save sequencer state to Pico flash so patterns survive power-cycle

Status: Open.

#6 In DIYSynthMNL/Pi-Pico-Random-Looping-Sequencer;

· NeoRecasata opened on May 14, 2026

Add prominent build note about Pi Pico clone GP29 (ADC3) requirement

Status: Open.

#5 In DIYSynthMNL/Pi-Pico-Random-Looping-Sequencer;

· NeoRecasata opened on May 14, 2026

1V/oct precision — add per-note tuning lookup table or hardware gain trim

Status: Open.

#4 In DIYSynthMNL/Pi-Pico-Random-Looping-Sequencer;

· NeoRecasata opened on May 14, 2026

Document analog input voltage-mapping + offset pot calibration procedure

Status: Open.

#3 In DIYSynthMNL/Pi-Pico-Random-Looping-Sequencer;

· NeoRecasata opened on May 14, 2026

Implement reading from the 4 analog input jacks (currently TODO in main loop)

Status: Open.

#2 In DIYSynthMNL/Pi-Pico-Random-Looping-Sequencer;

· NeoRecasata opened on May 14, 2026

Verify vOct output isn't being halved by R23 + load divider — add buffer if needed

Status: Open.

#1 In DIYSynthMNL/Pi-Pico-Random-Looping-Sequencer;

· NeoRecasata opened on May 14, 2026