Commands

• bootloader
  Restart to bootloader
• bus [on/off]
  Connects the bus to mains
• cls
  Clears screen
• eeprom [save/load]
  Saves/Loads the parameters to/from EEPROM
• get [parameter]
  If the parameter is given the function prints the value of the parameter. If no Parameter is given the functions prints all parameters with values.
• help
  Prints the help text
• kill
  Kills all coil operations
• load_default
  Loads the default configuration out of flash
• qcw [start/stop]
  Starts/Stops the QCW operation with repetition rate stored in qcw_repeat [ms]. Values <100 ms results in a single shot.
• reset
  Restarts the processor
• set [parameter] [value]
  Sets a parameter to the given value
• status
  Displays a status window in VT100 mode
• tasks
  Displays the task list with statistics
• tr [start/stop]
  Enables transient mode with the pulsewidth (parameter: pw) and delay between the pulses (parameter: pwd)
• tterm
  Enables the teslaterm mode (No user command)
• tune_p
  Starts the autotuning of the primary. WARNING: not for use with high bus voltage!!!!
• tune_s
  Starts the autotuning of the secondary. WARNING: not for use with high bus voltage!!!! The primary capacitor needs to be shortened.