Building the Flasher cable 2
Insert the 10 pogo pins into the nylon connector. You can use a small handdrill with an 1 mm drill to widen the holes a little bit if needed.
Be careful: The pogo pins are fragile. If you apple to much sideways force, they break easily
Safety warning: The pogo pins are very sharp. Take care when applying force, to not let them slip away. It hurts to have a pogo pin slip under your finger nails or into your skin. Be careful!
Put the pcb on top.
Applying flux might help. It's all a bit finicky. Nobody said it would be easy. ;-)
If you own a 3D printer, it might help to print a small jig to hold the pins in place. See this stl file
No glue needed, it is friction fit into place.
Instructions how to use: Connecting the flasher cable
