Tallac OpenNAC

This page describes how to configure to use OpenNAC API with Tallac AP.

Configure Tallac AP To Use OpenNAC API

The Elbrys SDN Developer Lab implements Tallac's OFNM protocol. This means that the SDN Developer lab will communicate with the AP to determine the required information.

In order for this to work you must first carry out these steps:

• Configure Tallac AP for RestConf API
• Configure a VNET on the Tallac AP using the Configuration:Virtual Networks tab on the left side of Tallac's management screen.
• Run an SDN application that targets the VNET you created. See OpenNAC Sample Applications for how to do this.

Once you have completed these steps, the SDN Developer Lab will communicate with the Tallac AP and auto-configure the OpenNAC API for the Tallac AP and it will appear in the Devices table on the SDN Developer Lab dashboard. You should refresh the Developer Lab dashboard while the SDN Application is running.

We last tested with Tallac firmware version: SDM-WP1F-release-3.0.11-488