Parameters
This page provides information on 3D printing equipment, materials, and printing parameters used in the project so far.
Ultimaker S5
Printcore 1:
- ColorFabb PLA/PHA Shining Silver 2.85 mm (3 rolls)
- ColorFabb PLA/PHA Sky Blue 2.85 mm (1 rolls)
Printcore 2:
- Ultimaker PVA Filament Natural 350g (1 roll)
| Setting | Value |
|---|---|
| Printcore 1 | AA 0.4 |
| Printcore 2 | BB 0.4 |
| Profile | Normal (0.15mm) |
| Infill Density | 20% |
| Infill Pattern | Triangles |
| Support | On |
| Support Extruder | Extruder 2 |
| Support Placement | Everywhere |
| Support Overhang Angle | 45 |
| Build Plate Adhesion | On |
| Build Plate Adhesion Type | Brim |
| Build Plate Adhesion Extruder | Extruder 2 |
| Dual Extrusion | On |
Unless otherwise stated, the content of this wiki is licensed under
